Rice-lake 880 Performance Series Indicator/Controller Techni Manual de usuario descargar pdf (Pagina 103)

Appendix 97

Table 10-5 lists the sub-parameters available when configuring a scale using INDUST mode. The table includes the

default values of the INDUST sub-parameters and the ef

fective (not configurable) values used by NTEP,

CANADA, OIML and NONE regulatory modes

Table 10-5. REGULA/INDUST Mode Parameters, Comparison with Effective Values of Regulatory Modes

REGULA/INDUST Parameter REGULA Mode

Parameter Description INDUST NTEP CANADA OIML NONE

SNPSHT Display or Scale weight source DISPLAY DISPLAY DISPLAY DISPLAY SCALE

ZTARE Remove tare on ZERO NO NO NO YES YES

KTARE Always allow keyed tare YES YES NO YES YES

MTARE Multiple Tare Action REPLAC REPLAC NOTHIN REPLAC REMOVE

NTARE Allow negative tare NO NO NO NO YES

CTARE Allow CLEAR tare to clear tare YES YES YES NO YES

PRTMOT Allow print while in motion NO NO NO NO YES

PRTPT Add PT to keyed tare print NO NO YES YES NO

OVRBAS Zero base for overload calculation CALIB CALIB CALIB SCALE CALIB

10.6 Data Formats

10.6.1 Stream Serial Data Format

If stream data transmission is configured

for the communication ports (STRLFT or STRIND), by default the 880

sends data using the Rice Lake Weighing Systems serial data format shown in Figure 10-1:

ASCII 02

decimal

Polarity:

< space > = Positive

<–> = Negative

W eight: 7 digits, right-justiﬁed, dummy

zer o es, d ecimal point w ith no leadin g

zer oes except for leading zer o immediately

pr eceding the decimal point. Leading

zer oes transmitted as spaces.

L = pounds

K = kilogram s

T = tons (T , TN )

O = ounces

G = grams

< space > =

NONE

G = Gr oss

N = Net

Status:

< space > = valid

I = Invalid

M = Motion

O = Over/under range

or <CR>

Z = Center zero

Figure 10-1. Stream Serial Data Format

SFMT parameterdefault – <2><P><W7.><U><M><S><CR><LF>

Note

Format can be changed, see Section 10.7.

The character values can be changed for the stream format tokens, see Table 6-10 on page 70.

If the COM port is set to TYPE = RS485, the port will not

stream data, and cannot be used in a local/remote

application. See Section 10.6.3.

10.6.2 Print Output Serial Data Format

When print format is configured for the demand

(print) port in the setup menus, the 880 uses a data string formatted

for a basic ticket printout. The particular print format printed depends on the indicator configuration. See

Section 7.0 for print formatting.

Use the EDP commands, Revolution

or the front panel to fully customize the print to work with a wide variety of

printers, and other remote equipment.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 119 120

Comentarios a estos manuales

Sin comentarios

Rice-lake 880 Performance Series Indicator/Controller Techni Manual de usuario Pagina 103

Comentarios a estos manuales

Relacionado con productos y manuales para Escamas Rice-lake 880 Performance Series Indicator/Controller Techni